Determine The In-Situ Dry Density Of Soil By Core Cutter Method

Posted in Civil Engineering Tests | Email This Post Email This Post |
Print Friendly

This test is done to determine the in-situ dry density of soil by core cutter method as per IS: 2720 (Part XXIX) – 1975.The apparatus needed for this test is

i) Cylindrical core cutter
ii) Steel dolley
iii) Steel rammer
iv) Balance, with an accuracy of 1g
v) Straightedge
vi) Square metal tray – 300mm x 300mm x 40mm
vii) Trowel

Procedure Determine The In-Situ Dry Density Of Soil By Core Cutter Method
i) The internal volume (V) of the core cutter in cc should be calculated from its dimensions which should be measured to the nearest 0.25mm.

ii) The core cutter should be weighed to the nearest gram (W1).

core-cutter-method

iii) A small area, approximately 30cm square of the soil layer to be tested should be exposed and levelled. The steel dolly should be placed on top of the cutter and the latter should be rammed down vertically into the soil layer until only about 15mm of the dolly protrudes above the surface, care being taken not to rock the cutter. The cutter should then be dug out of the surrounding soil, care being taken to allow some soil to project from the lower end of the cutter. The ends of the soil core should then be trimmed flat in level with the ends of the cutter by means of the straightedge.

iv) The cutter containing the soil core should be weighed to the nearest gram (W2).

v) The soil core should be removed from the cutter and a representative sample should be placed in an air-tight container and its water content (w)

REPORTING OF RESULTS
Bulk density of the soil g cc Y = [W2 – W1]/ V g/cc
Dry density of the soil g cc Yd = 100Y/[100+w] g/cc

Average of at least three determinations should be reported to the second place of decimal in g/cc.
A sample proforma for the record of the test results is given below

in-situ-data

More Entries :
Comments
  • s.s.hati July 8, 2011 at 11:37 am

    What is the nos of core to be taken of 1000 sq.m in case of circular area and in case of rectangular area ( of width 5m ,length 200m) for testing sand compaction of 200 mm thk. Layer?

    • jess August 23, 2011 at 12:16 am

      every 500m2 = 1 point of test~

  • Keshav R Kulkarni. September 19, 2011 at 4:31 am

    Core recovery should be not less than 25%.Not understood.Please comment

  • Asoke Mandal December 21, 2011 at 12:17 pm

    SHOW THE FULL PROCEDURE FOR TESTING OF SOIL BY CORE CUTTER METHOD WITH NESSESARY PICTURE

  • waqas February 5, 2012 at 4:41 am

    what is the method to check the soil particles which made the different properties of soils

  • bass February 24, 2012 at 1:04 pm

    what happens when construction work is carried out with sugar water?

  • dinesh babu n April 14, 2012 at 10:48 pm

    what is the minimum average value of dry density of soils .and liquid limit value

  • tushar n patel August 9, 2012 at 1:55 pm

    How many numbers of test should be performed per square mentre of earth filled up area to check the compaction of test?

  • ch. prabin chandra September 14, 2012 at 8:44 am

    sand replacement method is accurate than core cutter method test…

  • Fahad satti October 17, 2012 at 1:02 am

    In which soil core cuttertmethod can be used.

  • krishan Sameera May 6, 2013 at 10:37 am

    sir could u please explain limitation of this test

  • pawan gurve August 25, 2013 at 9:56 am

    please send me the viva questions based on the all experiments of GT-1 including core cutter method and all.

  • Monim ul Islam August 27, 2013 at 7:16 am

    Every 1000 m2 10 nos. points required for density test (Compaction Test)

  • Deepak Nandedkar September 11, 2013 at 11:27 pm

    Why we determine bulk density and dry density of sand by 2 different methods?
    And what is the conclusion?

  • b.govindharajan January 17, 2014 at 3:04 am

    how convert desity in to load in terms of newton

  • k chinna sai kumar July 6, 2014 at 8:17 am

    what is the use for calculating the density of soil

  • Post a comment

1 2

Share Information

What is Civil Engineering

Journals Books And Softwares

Branches Of Civil Engineering

Civil Engineering Jobs

Follow Us On FB

Knowledge Center

Civil Engineering Universities/Events

Gallery - Civil Engineering Pictures

Civil Engineering Forum

civil engineering forum

Search


engineeringcivil.com awarded best online publication by CIDC 2013

Top Contributors

Yahoo Group - Civil Engineering Portal

Subscribe to EngineeringCivil.com


Powered by groups.yahoo.com

Recently Added

Civil Engineering Links

anglo.com

Follow Us On FB